Pick up a new braid and repeat the dipping process.Gather all of your braids on one shoulder. Pick up the end of one box braid and dip the last 1/2 inch of it into the hot water.Heat a saucepan half full of water on the stove until the water starts to boil. Dab the braid lightly on the towel to catch the water drips, and then hold it … Pour the oil into the bowl or mug of water.Big old box braids not only look great, they are super easy to care for and style. Olivia asked this question because her braids won’t stop unraveling and she constantly has to re-braid the ends of her braids throughout the day so I hope this video helps you!2nd Answer: Use a braid sealer instead of a cigarette lighter.1st Answer: Dip the ends in hot water!
3rd Answer: If you already have a pattern on the ends that you like because you use curly, wavy, or straight braiding hair, apply a couple of drops of nail glue near the ends of your braids. Make sure to braid at least 2-3 inches past your hair before you apply 2-3 drops of nail glue onto your braid. The mug will need to be close enough so that you can bend over it.Open a bottle of baby oil and pour the oil into the bottle's cap until it almost reaches the top. She has a degree in journalism from the University of Georgia and began writing professionally in 2001.Place a towel around your shoulders and set the mug on a table near a comfortable seating location.
One major downer with synthetic box braids is that they have a tendency to curl or unravel at the ends. Gather all of your braids on one shoulder. Hold the braid in place for five to 10 seconds and then remove it from the water. You can solve this little style nuisance using a little heated water, which locks the style in place.Place the braid over your opposite shoulder so that it stays separate from the others.
Many have done this before but heres me trying it out and ending up with great results. If your natural locks don’t have the length you crave, synthetic hair can achieve the look in no time. Pick up the end of one box braid and dip the last 1/2 inch of it into the hot water. You have to dip the ends alone in hot water or roll your ends in cold wave rod rollers and dip them in hot water.3rd Answer: If you already have a pattern on the ends that you like because you use curly, wavy, or straight braiding hair, apply a couple of drops of nail glue near the ends of your braids.Its a lot safer because you will NOT see flames, your will NOT burn yourself you you will BARELY see fumes.Make sure to braid at least 2-3 inches past your hair before you apply 2-3 drops of nail glue onto your braid.
Nail Glue Used To Seal Braids Dab the braid lightly on the towel to catch the water drips, and then hold it in your hand for 30 to 60 seconds while it cools.Continue dipping each braid into the hot water until all of the ends are sealed.Hold the braid in place for five to 10 seconds and then remove it from the water.Pour the boiling water into a bowl or large mug, taking care not to burn yourself.Kimberly Johnson is a freelance writer whose articles have appeared in various online publications including eHow, Suite101 and Examiner.